- Manufacture is available of elbows with bending angle being a multiple of 5 degrees and diameter ranging from 50mm to 960mm.
- Products are designed for pressure of up to 1.6MPa or vacuum of up to 0.08MPa depending on the operating conditions and installation location.
For more detailed information, see the "Industrial rubber pipes" catalogue.
The elbow consists of internal wear-resistant rubber layer reinforced with cord fabric, and external protective rubber layer.
The rubber elbow is installed with the use of bolts or clamps, which does not require the use of special tool.
Available elbow designs:
flanged: rubber-coated steel flange/steel swivel flange on either side or both sides.
without flanges: clamp connection.
Greater diameter elbows are available on Customer’s request
Manufacture is available of metallic elbows lined with wear-resistant rubber layer or polymer composite compound
Manufacture of products according to the Customer’s drawings and technical requirements depending on the specific operating conditions is available
